校正旋轉樣品盤和 R 軸：

1. 在 ACQUITY 控制臺的左側樹型菜單中選中樣品管理器。Select Troubleshoot > Service Mode, and enter the service mode password.

2. 選擇“故障排除”> Service Mode（服務模式），然后輸入服務模式密碼。Select Troubleshoot > Service Mode, and enter the service mode password.

3. 單擊“維護”>“校正旋轉樣品盤”。

4. 取下樣品管理器門絕緣體上的校正銷，并按照軟件提示進行操作。Remove the calibration pin from the insulation on the sample manager door and follow the software prompts.

5. 軟件會提示您安裝校正銷。將校正銷插入托盤 1 右外側的孔中，并將其與樣品管理器前底盤上的孔（中間偏左）對齊。Software prompts you to install the calibration pin. Place the pin in the hole of tray 1 on its outer-right side and line it up with the hole in the front chassis of the sample manager, just left of center. （界面顯示step2時，將pin的長短穿透到樣品盤1的孔和底盤下的孔進行固定）

6. 如果 ACQUITY 控制臺中仍然突出顯示樣品管理器，轉到“維護”>“校正 R 軸”。

7. With the sample manager still highlighted in the ACQUITY console, go to Maintain > Calibrate R-axis.

8. 軟件再次提示將校正銷安裝在托盤 1 的孔內。此時校正銷將翻轉，無法穿透到底盤。

Software again prompts for calibration pin to be installed in hole of tray 1. This time the pin will be flipped over so it cannot go through to the chassis.

1. 將針與校正銷頂部的小孔對齊。您必須使針盡量靠近孔，但不要將針?lè)湃肟字小?/span>Align the needle with the small hole at the top of the calibration pin. You need to get the needle to the hole as close as possible without placing the needle in the hole.

2. 校正完成后，返回“故障排除”> Service Mode（服務模式），然后輸入服務模式密碼將其禁用。

Once the calibrations are complete, go back to Troubleshoot > Service Mode, and enter the service mode password to disable it.?