A-B-1394C-SJT22-A伺服驅動 伺服電機

A-B-1394C-SJT22-A

??A-B-1394C-SJT22-A

A-B-1394C-SJT22-A伺服驅動 伺服電機

VMIVME-4100的一個獨特功能是內置測試邏輯，它允許

通過使用板載多路復用器和VMIVME-3100 ADC板測試任何一個模擬輸出通道。在測試模式下，字段

通過連接器P3的連接可以被隔離，16個通道中的任何一個都可以

可以通過VMIC的模擬背板（AMXbusTM）路由到12位ADC板。

程序控制下的ADC板可以將模擬信號轉換為

12位數字字，并與寫入DAC的原始12位字進行比較

板通過這種方式，可以驗證16個模擬輸出通道中的每一個

不會干擾現場連接的設備。模擬輸出通道可能

也多路傳輸至模擬測試總線，同時控制P3

連接現場設備，提供輸出的實時故障檢測。如果董事會

自檢失敗，前面板上的故障LED可能會亮起，以指示

電路板處于故障狀態。完整的操作和要求

本手冊第3節“理論”詳細解釋了自檢模式

操作，以及第4節，編程。

A unique feature of the VMIVME-4100 is the Built-in-Test logic that allows

the testing of any one of the analog output channels through the use of an onboard multiplexer and the VMIVME-3100 ADC Board. When in test mode, the field

connections through connector P3 may be isolated and any of the 16 channels

may be routed to the 12-bit ADC Board via VMIC’s Analog Backplane (AMXbusTM).

An ADC Board under program control may have the analog signal converted to a

12-bit digital word and compared with the original 12-bit word written to the DAC

Board. In this manner, each of the 16 analog output channels may be verified

without disturbing the field connected devices. The analog output channels may

also be multiplexed to the Analog Test Bus, simultaneously controlling the P3

connected field devices, providing real-time fault detection of the outputs. If a board

fails its self-test, a Fail LED on the front panel may be turned on to indicate the

board is in a failed condition. The complete operation and requirements for the

self-test mode are explained in detail in this manual in Section 3, Theory of

Operation, and Section 4, Programming.